Read This Before You Decide To Choose A Diamond Blade

Before you decide to buy a diamond blade, there are several things you should take into consideration: the initial price of the Diamond blade or the cost per cut. For smaller working or occasional use, low priced blades may be preferable. On the other hand, for larger jobs or regular use, a higher priced blade will actually be less expensive to use because it will deliver the lowest cost per cut. For really big jobs, the lowest possible sawing cost (cost per foot) is usually much more important than the initial price.

A list of different types of diamond blades is provided on our webpage. There is a corresponding symbol for each, and these symbols are used throughout the catalog to help you locate the right blade. Blades that are to be used on power cutters have to be rated at higher rpms. All Husgvarna high-speed cut-off blades are rated at the appropriate, higher rpms.

Correctly identifying the material you are going to cut is the most important factor in choosing diamond blades. It directly affects the cutting speed and the life of the blade. You will find diamond blade recommendations charts throughout the catalog to help you locate the proper blade for your job. Most Husqvrna blades cut a RANGE of materials. For maximum performance (cutting speed and life), the material should be matched to the blade as closely as possible. As a general rule, determine the material which will be cut most often, or the material for which top blade performance is most important.

Choosing wet or dry may be a matter of user preference or job requirement. When using a power hand tool such as a power hand saw, it is not safe to use water because of the electrical power source. However for concrete saws blade, wet cutting is usually preferred because you can cut deeper when using water as a coolant. For tile and masonry saws, either wet or dry cutting blades can be used. For power cutters, dry blades are more popular, but they are often used wet to control dust. Wet blades MUST be used with water. Dry blades may be used EITHER dry OR wet, as the job or equipment allows.

Total segment heights may be misleading because of non-diamond bearing segment bases necessary for the laser welding or brazing process. That is why Husqvarna shows you exactly how much of each segment has diamonds and can actually be used to cut.

Diamond blade segment height by itself is not a true measure of a blade segment height by itself is not a true measure of a blade’s value. Many other factors affect a blade’s performance and consequent value. Consider the diamond size, concentration and quality, the hardness of the bond, the cutting power (torque) of the saw blades, and how well the blade specification is matched to the material being cut.

Dry cutting diamond blades may be used dry, eliminating the need for water tanks, water hoses or wet slurry clean-up. These blades depend on airflow around the blade to prevent excessive heat build-up during cutting.

Use dry diamond blades for “intermittent” sawing. After every 10 to 15 seconds of cutting, take pressure off the blade and allow it to run back up to full speed for several seconds. This “cooling” interval allows air to flow around the blade and dissipate the heat. Use dry diamond blades ONLY for shallow cutting (1-2” deep) or step cutting (making several shallow passes to reach the full depth required).

Husqvarna dry cutting diamond blades are also designed to cut equally well wet, if the job or equipment permits. Wet cutting diamond blades MUST be used with water to prevent excessive heat build-up during cutting. Using water on the blade also reduces dust and helps remove cuttings.

A continuous water flow is critical. Using “wet” blades without water, even for a few seconds, causes excessive heat and blade damage, and creates a safety hazard. Check the saw or tool carefully before using a wet cutting diamond blade. Make sure it is safe to use the saw or tool with water.